基于单片机的USB设计方案，该方案包括了电路原理图、PCB布局图、单片机端的源程序和PC端的USB调试助手，该方案内容详尽。...

基于AT89S8253单片机的LCD驱动程序代码，用c语言编写-AT89S8253 MCU-based LCD driver code, using c language

此程序是用于AVR单片机驱动FLASH的,对于用AVR单片机进行开发的朋友,提供了一个例程,还有对于对使用FLASH没有经验的朋友也有很好参考价值-this procedure is used AVR Flash Drive, AVR for use for the development of a friend, provides a routine, There FLASH for the right to use the lack of experience has become a good friend reference value

kemi12864LCD源程序用kei uvision打开-kemi12864LCD source with open Kei uvision

pwm改变占空比的程序，已调试过，可以直接用KEIL使用-pwm duty cycle to change the procedures have been debug, and can be directly used by KEIL

友善臂开发板上使用的触摸屏驱动，s3c2410，2.6内核下使用-The development of friendly arm on the board using touch-screen driven, s3c2410, 2.6 kernel use

用KEIL开发的操作C51单片机的IO口，使得完成对IO口的读写等操作-KEIL development operation with C51 MCU IO mouth, making completion of the IO port to read and write operations, etc.

利用mega128控制由L298和L297构成的驱动板，驱动步进电机-Mega128 control using L298 and L297-driven composition of boards, stepper motor driver

本程序为简单的12232F型LCD液晶显示及键盘功能程序 K1键为进入调整，进入后显示四个0，再次按下为退出调整，初始状态 为首行显示河北工程大学 K2键为进入调整后加一 K3键为进入调整后减一 K4键为光标右移 -This procedure is simple 12232F-LCD liquid crystal display and keyboard function keys for entry into the program K1 adjust, enter the show after four 0, once again press for the withdrawal adjust, line shows the initial state, headed by Hebei University of Engineering K2 adjust keys for entry into the after One key for entry into the K3 adjusted by one for the cursor keys K4 shifted to right

一个用汇编编写的51单片机发声程序,内嵌一首简单歌曲"八月桂花香"。-Used to prepare a compilation of 51 single-chip voice procedures, embedded in a simple song

《单片机应用系统开发实例详解》 光盘 程序-err