用单片机控制max7219做的led灯的动态显示

一个C语言编写的单片机并口数据发送代码-an bunch of computer parallel port data transfer code programmed with C

P89CXX编程器控制CPU接收和控制程序-P89CXX Programming Control CPU to receive and control procedures

实验采用七段码LED设计（数码管），显示直观；采用定时器中断，计时更准确；功能齐全，可随时启动、停止、清零，后者智能化程度更高。-Seven-Segment LED code using the experimental design (digital control), visual display using timer interrupt, a more accurate time functions, may at any time to start, stop, cleared, and the latter an even higher degree of intelligence.

24系列eeprom的读写程序，绝对经典，只要根据自己需要改一改就行，采用模拟IIC总线的方式-24 Series EEPROM reading and writing process, an absolute classic, as long as the need to simply on the basis of their own line, using simulation methods IIC Bus

C8051F单片机的以太网测控源码与资料-C8051F Ethernet monitoring and information source

24c16 收发程序 8051单片机-24c16 transceiver procedures 8051

使用vs1003芯片制作的mp3播放器。-Produced by using the vs1003 chip mp3 player.

频率计是用单片机89C51和几块数字电路几个三极管-Frequency meter is used and a few 89C51 single-chip digital circuit several triode

根据公版自己做的usbasp板，添加了usbcdc。-According to the public version of their own to do usbasp board, added usbcdc.

（个人原创）这个是我在Keil下写的MAX5532--MAX5535通用的驱动代码，由于我编写的时候，考虑到通用性，所以当你使用的时候，需要根据你的器件特性几乎不用修改函数提来调用我的函数模块（我在需要调用的注释和注意点已经写的很清楚了），缩短你的工程开发周期。-(Personal original) This is what I wrote in under Keil GM MAX5532 MAX5535 driver code, as I am prepared when taking into account the general, so when you use when you need to almost do not modify the device characteristics mentioned function to call I have a function module (I need to call attention to the comments and points have been written very clearly), and shorten your project development cycle.