12864中文字库测试程序 ST7920

PIC 单片机 电机的控制代码设计及参考电路原理图。C语言代码。-PIC Microcontroller motor control code and reference design circuit schematics. C language code.

对于 压力传感器的 51单片机的处理 程序 外加 仿真-Pressure sensors for 51 plus SCM process simulation

51单片机驱动青云创新的LCM3202403的源码，采用控制器方式，控制器为S1D137-51 single-chip driver LCM3202403 Albatron source of innovation, using the controller mode, the controller for the S1D13700

一个单片机最小系统，含AD,DA,LED,KEYBOARD-A microcontroller minimum system, including AD, DA, LED, KEYBOARD

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

十种软件滤波.rar介绍了十种软件滤波的方法,不过我建议还是使用模拟滤波方法好.-10 kinds of filtering software. Rar introduction of dozens of software filtering method, but I suggest that the use of analog filtering methods or good.

PIC16F71 C语言的ADC示例程序。已附上详细说明。

ds1820+1620液精显示时间，温度-ds1820+ 1620 precision liquid display time, temperature

单片机FM收音机芯片（cs1100）程序 -Single-chip FM radio chip (cs1100) procedures