24c01 good c language code, as the pilot can use, share

实时时钟芯片ds1302的应用和c51程序,调试过的.-ds1302 real-time clock chip decoder and the application procedures, debug before.

16位单片机xc164用于QH2001显示。-16 Singlechip XC164 for QH2001 show.

自动交通管理系统 用红、绿、黄三支共两组发光二极管表示交通信号灯，利用单片机模拟有时间显示的定时交通信号灯控制管理。信号灯的变化规律可如下： 1）放行线：绿灯亮放行25秒，黄灯亮警告5秒，然后红灯亮禁止。 2）禁止线：红灯亮禁止30秒，然后绿灯亮放行。 3）当某一方向的红灯亮时，若该方向有车通过，则用扬声器声报警。（撞红灯信号可用3-5V模拟量表示） 同时用2位数码管进行30秒钟递减时间显示。-automatic traffic management system using red, green, yellow a total of three light-emitting diodes, said two traffic lights, using SCM time simulation shows the regular traffic signal control. Signal changes in the law to be as follows : 1) Release Line : green clearance 25 seconds, bright yellow warning five seconds, and then the red-ban. 2) prohibit the lines : red-Ban 30 seconds, then green clearance. 3) When the red light in one direction- that if the direction of a car passed, the use of loudspeakers sound alarm. (Red light signals can hit 3- 5V analog said), while using two digital tube for 30 seconds decreasing time displayed.

模拟交通灯，并带有数字显示的程序。初始时全为红灯，显示“HELLO”字样。然后交通灯以“红绿、红黄、绿红、黄红”四种状态做循环，而且黄灯会闪烁，每种状态都带有到数记时。当按下P3_2时，变成“红红”状态，并显示“STOP”字样！ -simulated traffic lights and figures with the procedure. When all of the initial red, shows that the "hello" words. Then traffic lights to the "black, red and yellow, green, red, yellow red" state to do four cycle, but the yellow light flashes, each state will have a few to remember when. When pressed P3_2, into a "red" state, and shows that the "STOP" word!

一个单片机的按键程序。没有使用延时。但是使用其他的方式来达到了延时的目的。-A single-chip key procedures. Do not use the delay. However, the use of other means to achieve the purpose of delay.

CF卡转换成IDE标准接口的电路图，个人的意见可供大家参考-err

这个是单片机和电脑进行通信的单片机作为上位机向电脑发送数据-This is a single-chip and single-chip computer to communicate to the computer as a host computer to send data

EMC的开发库 是单片机性价比高的选择 提高快速开发-EMC microcontroller development libraries are cost-effective option to enhance rapid development of high

MSP 430 计算机USB接口之间的通讯代码-MSP 430 computer communication between the USB interface code