bios source code, based on legislation s3c44b0 Hangzhou

标准c++,c和汇编实现，仅支持ARM7,目前还不支持DEBUG，下一版本将支持-standards c, c and compilation achieved only support ARM7, does not yet support DEBUG, the next version will support

本程序是用虚拟USB将stm板连接到PC机上的程序。在这种情况下，它使用USRT模式或USB主机。

看MIPS跑LINUX－MIPS体系结构剖析,对于深入理解MIPS架构思想很有用的，记得当初在华为的时候，很多人都有一本MIPS架构剖析，如果大家有什么不懂的，欢迎交流-See MIPS Run LINUX-MIPS architecture analysis, for in-depth understanding of MIPS architecture ideas useful, remember when Huawei, a lot of people have a MIPS architecture analysis, if we do not know of any, please share

天嵌SKY2440，核心板和底板的原理图和PCB图，用protel99打开-Days embedded SKY2440, core boards and backplanes and PCB schematic diagram, with protel99 Open

开发环境:ADS 1.2/SDT 2.51 GUI测试，由于没有触摸屏，所以将触摸屏的代码给屏蔽了； 请将FS44B0II开发板连接好交叉网线、直连串口线、电源， 并连接好G57液晶屏，同时还要连接好背光电源； 然后在BIOS的命令窗口里面敲netrun命令； 点击FS44B0_G57_uCGUIuC-GUIFS44B0_G57_uCGUI_DataDebugRel目录下： 批处理文件FS44B0_G57_uCGUI.BAT 下面你就可以看到液晶屏上面显示优龙标志 它会延时一两秒中进入下一个画面，逐步延时GUI的各项功能，请耐心观看； -Development Environment: ADS 1.2/SDT 2.51GUI test, because there is no touch screen, it will be touch screen to shield the code Please FS44B0II development board to connect a good cross-network lines, direct serial lines, power supply, and connect a good G57 LCD screen, at the same time, good backlight power supply connection and then in the BIOS command window knock netrun order Click FS44B0_G57_uCGUIuC-GUIFS44B0_G57_uCGUI_DataDebugRel directory: batch file FS44B0_G57_uCGUI.BAT below you can see the LCD screen above shows excellent signs that it will delay Liuzhou 1 two seconds to enter the next screen, and gradually delay the GUI features, please be patient watch

ARM开发软件使用教程-ARM software directory

ADS1241 ADS1241的程序-ADS1241 ADS1241 procedures

东南大学开发ARM7芯片sep4020的key+tft程序代码-Southeast University to develop ARM7 chip sep4020 the key+ Tft code

ARM S3C2410处理器 iic总线驱动程序 开发环境：ads1.2-ARM S3C2410

TI microprocessor, most about CAN2.0 development