ARM开发软件使用教程

A simple C program to strobe the LEDsvia Port D. The strobe rate is to be set by adjusting the voltage drop over a potentiometer that is sampled by an ADC.

这是关于LPC2100 ARM处理器在CAN中应用的实例.运行环境是KEIL ARM.-This is on the LPC2100 ARM processor in the CAN application examples. Runtime Environment is KEIL ARM.

This test code use PWM to control LED flashing, however, users can use PWM to do other things with the PWM initialization code-AT91SAM7S test code for PWM development under IAR platform

ISD公司的语音芯片录音电路。语音录放必看资料。-ISD"s voice recording circuit chip. Watchable voice recorders information.

ARM9内核的 mmu内存管理机制介绍.-ARM9 core MMU memory management mechanism of introduction.

SMALL RTOS是为小ram系统单片机编写的,目前仅在51系列单片机上成功运行,还没有在其它单片机上移植(目前我仅有51和avr的开发系统).在小ram系统单片机如51系列上运行tcp/ip 协议栈是不太现实的.一般tcp/ip 协议栈需要在32位单片机上运行,在8位机上运行太勉强(51是8位机),除非您只运行ip协议.建议使用ucos/ii操作系统或是嵌入式linux,并选用arm或龙珠系列单片机-SMALL RTOS for small microcontrollers ram system, written in 51 series of microcontrollers currently only on the successful operation, no other MCU on the transplant (currently I am only 51 and avr development system). In the small ram System-on- machines such as the 51 series of films running on tcp/ip protocol stack is not very realistic. General tcp/ip protocol stack need to run 32-bit microcontrollers in the 8-bit machine running Taimian Jiang (51 is the 8-bit machine), unless you run only ip protocol is suggested. ucos/ii operating system or embedded linux, and use arm or Pearl Series MCU ..

步进电机是将电脉冲信号转变为角位移或线位移的开环控制元件。在非超载的情况下，电机的转速、停止的位置只取决于脉冲信号的频率和脉冲数，而不受负载变化的影响，即给电机加一个脉冲信号，电机则转过一个步距角。-Stepper motor is the electrical impulse signals into angular displacement or linear displacement of the open-loop control components. In the non-overload case, the motor speed, and stop location depends only on pulse frequency and pulse number, regardless of the load change, that is, to add an electrical pulse signal, then turn one motor step angle.

ARM7TDMI Revision: r4p1 Technical Reference Manual.

Hey. This some pid code for the atmega88 that I once used to control a heater. It s purpose is pretty specific, and I only wrote it to work on the mega88, so the code itself won t be too useful. It is a good place to start if you re trying to use or figure out pid though.

MIB的参考代码,有IDB_GET,IDB_SET,和IDB_NVM_SET的具体写法和说明-MIB reference code, IDB_GET, IDB_SET, and the specific wording IDB_NVM_SET and notes