用单片机控制GPS模块C51源代码。。希望对大家了解单片机控制GPS有帮助。...

这是关于Proteus仿真的源程序，用于ARM7，编译环境为ADS-This is the source on the Proteus simulation for the ARM7, the compiler environment for ADS

AVR MEGA162控制语音芯片控制 OSYNO6188 TTS的代码，完成初始化及发声测试-AVR MEGA162 control OSYNO6188 TTS voice chip to control the code, complete the initialization and audible test

这是一个芯片资料,可以为单片机初学者提供一个认识芯片的文档.对学习单片机的同学有帮助-This is a chip data, we can provide an understanding of single-chip chip beginners document. MCU learning students have to help

uPSD34xx Disk driver

ADS编译，CANOPen协议栈源代码，使用PIC18微处理器-ADS compiler, CANOPen protocol implementation code，A CANopen Stack for PIC18 ECANTM Microcontrollers

P串行实时时钟芯片DSl302程序设计中的问题与对策-P serial real-time clock chip DSl302 program design problems and countermeasures

software MPLAB... writing program (coding .c/.h) -software MPLAB... writing program (coding .c/.h)

由8051组成的单片机系统通常情况下，P0口分时复用作为地址、数据总线，P2口提供A15-A8即高8位地址，P3口用作第二功能，只有P1口通常用作I/0口。P1口是8位准双向口，它的每一位都可独立地定义为输入或输出，因此既可作为8位的并行I/O口，也可作为8位的输入输出端。当工作在输入方式时，对应位的锁存器必须先置1,才能正确地读到引脚上的信号,否则,执行读引脚指令时,若对应位的锁存器的值为0，读的结果永远为0。-By 8051, composed of single-chip microcomputer system under normal circumstances, P0 timeshare I reuse as address, data bus, P2 I provide A15-A8 high eight address, P3 mouth for the second function, I usually only P1 for I/0 I. P1 I was eight quasi-two-way port, it can be independent of each and every defined as input or output, it can be used as 8-bit parallel I/O port, can also be used as 8-bit input and output side. When the work in the input, the corresponding bit latch must first buy one in order to correctly read the signal pin, or pin the implementation of reading instruction, if the corresponding bit latch the value of 0, Reading the results of Forever to 0.

控制电机运动的C51单片机程序:定位控制,速度控制等

LCM19264液晶显示模块的底层驱动程序，引脚连接已经在程序文件中说明-LCM19264 the bottom of liquid crystal display module drivers, pin connections have been described in the program files