介绍了ucos在ARM上移植过程与注电事项

舵机控制（按键实现），通过按键来控制舵机的旋转（值固定）(Steering gear control (key-press implementation))

ucos for 2410 Bootloader,for norflash-OUT for 2410 Bootloader, for norflash

这是三星公司arm9 2410编写的LCD驱动程序，采用codewarrior编写。(This is arm9 2410 Samsung LCD driver prepared using the preparation of codewarrior.)

此为整套uC/FS程序，内含示例工程，运行绝对无错误、无警告，更关键的是内含详尽的英文使用手册。(wonderful～)

ucfs1.34版本,ucgui3.14版本,ucos2.76版本 可以用于arm系统-ucfs1.34 version, ucgui3.14 version, ucos2.76 version can be used to arm the system

本例程基于正点原子迷你stm32开发板，跑ucos-iii驱动DHT11(the program is run to stm32, it`s for ucos driver dht11 module, display temp&humi)

ucos是一个非常优秀的嵌入式操作系统，但作者只提供了bc下测试与调试代码，非常难于调试与学习，特别是初学者。vc是windows下非常优秀的IDE,如果把ucos移植到vc下运行，将非常方便ucos的调试与学习，有利于于ucos的推广。此项目的目的是希望能够把ucos及其相关的文件系统ucfs，GUI界面ucgui，网络tcp/ip都移植过来，方便广大爱好者学习。版本历史：ucos_vc0.11 时间：20050409描述：继续移植了Genie shell for UCOS II，为下一步文件系统的实现做准备ucos_vc0.1：时间：20050403描述：移植了完整的ucos到vc下，实现了vc下的ucos多任务系统-CENTER is a very good embedded operating system, the authors provided only bc under test and debug code is very difficult to debug and learning, especially beginners. Vc under windows is excellent IDE, if transplanted to vc CENTER run, it will be quite easy CENTER debugging and learning, is conducive to the promotion CENTER. The objective of this project is to be able to give CENTER and its associated file system ucfs, ucgui GUI interface, network tcp/ip all transplant, the majority of enthusiasts facilitate learning. Version History : ucos_vc0.11 Time : 20050409 Description : to transplant the shell for UCOS Genie II, the next step for the realization of file system to prepar

邵贝贝写的《嵌入式实时操作系统ucOS II》，最后面API参考手册，对每个函数的介绍页面都添加了目录，方便查阅。(Shao Beibei write embedded real-time operating system ucOS II, the rearmost API Reference Manual, on the introduction page for each function are added to the directory for easy access.)

stm32实时显示ADC采集的数值，显示在触屏版上(showing the data of ADC)

mcf522xx EV板的驱动程序源码，可以直接使用。该驱动本人测试过。-mcf522xx EV Board driver source code can be used directly. The driver I tested.