stm32f103 cortox

Running an Application from Internal Flash Memory on the tms320c2812.

profibus开发包4从站开发spc3芯片固态程序源代码-PROFIBUS Slave 4 Development Kit to develop SPC3 chip solid-state source code

ecc nandflash156501362相关资料，这些资料可以为开发NANDFLASH程序的人员带来好处-ecc nandflash156501362 relevant information, they can be for the development of procedures for staff benefits NANDFLASH

initial flash and sdram

ARM7核 S3C44B0 NAND FLASH烧写配置文件。 -ARM7 core S3C44B0 NAND FLASH Shaoxie configuration file.

S5PV210芯片内核移植:linux内核输入子系统:Tiny210v2底板上面有八个按键，但是官方只提供了该按钮的驱动，并没有实现输入子系统，使得板上的八个按钮没有任何作用。这里就通过向内核添加该buttons的输入子系统驱动，使该八个按钮实现如普通键盘的键值功能，实现能上下左右，以及确认等功能，就像手机的音量键、关机键一样。

关于ATMEGA128高级应用的C语言程序,有1000多行.-ATmega128 advanced applications on the C language program, there are more than 1000 lines.

..................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

ADSP的芯片原理图库-ADSP chip Principle Gallery

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (