assembly language to write electronic

脉冲测速代码。在51单片机上使用。可用于电动机。-Pulse Speed code. 51 SCM in use. Can be used in electric motors.

MSP430F1611串口程序 MSP430F1611串口程序-MSP430F1611 serial serial procedures procedures MSP430F1611

51上运行UCOSII，你要是想移植，但是不会，可以看看，有启发-51 UCOSII run, if you want to transplant, but will not, can see that enlightening

这是一个信号发生器的程序，适用于iar环境，可用于msp430的单片机 -This is a signal generator procedures, applicable to iar environment, can be used for MSP430 microcontroller

用数码管显示测得的心率值。并控制发光二极管的亮灭。-Digital display of heart rate measured value. And control of light to eliminate light-emitting diodes.

压力传感器PDF文档，开发按摩系统必备资料-Pressure sensors PDF document, essential information on the development of massage system

采用实时芯片DS1302来计时,并用LCM液晶显示!有较高的精确度!-Real-time chip DS1302 to time, and LCD LCM! Have higher accuracy!

PCB电路板。键盘控制，矩阵键盘的电路图。-PCB circuit boards. Keyboard control, matrix keyboard circuit.

此程序为自行车计附带产品．可以计里程，计速度．清零等功能．采用霍尔传感器传输信号，单片机采用中断扫描．然后用数组的形式在LED上显示．-procedure for bicycles or spin-off products. Total mileage can be up speed. Reset function. Hall sensor used for signal transmission interrupt SCM scan. Then in the form of an array of LED show.

用8253-8255编写的定时响铃程序 可以定时两个时间点，很经典的程序-spent 8253-8255 prepared by the regular beep procedures regular two points in time, classic procedures