MSP430单片机的LCD控制器SED1335子程序

控制板与串口通信程序 用串口命令让汽缸动作-Control panel with the serial communication program so that the cylinder moves with the serial command

上位机与单片机之间的通信,非常的容易,看了你也便会!-PC and communication between the microcontroller, very easy to read you will!

Interface Design Vehicle Busses Computer buses Peripheral buses Instrumentation buses Vehicle buses

汇编程序，将tab中的256个数据通过串口发送-Assembler will tab of 256 data sent through the serial port

Proteus

LCD driver HX8802_datasheet

将单片机的IOA0~IOA7分别接按键S1~S8连接到高电平上。此时，如果某个按键被按下，对应的I/O端口就会输入高电平进单片机，即按键S3按下，IOA2会输入高电平进单片机-Will Singlechip IOA0 ~ IOA7 access keys, respectively, S1 ~ S8 is connected to high on. At this point, if a button is pressed, the corresponding I/O port will enter into the high single-chip, that is, S3 button press, IOA2 will enter into single-chip high

LED扫描驱动程序，是16分之一扫描，包含多种模式，闪烁时间可调。-LED Scan driver, is one of 16 sub-scanning, contains a variety of patterns, adjustable flashing time.

周立功的EazyARM2200的模板，里面还有ucos的模版，还有ARM和Thumb两种模式下的模版-Ligong EazyARM2200 weeks of the template, there is also uCOS template, there are two types of ARM and Thumb mode template

measure coin used 89c52,which use two Timers -measure coin used 89c52, which use two Timers