键盘扫描及返回相关数据,只是读键盘与功能实现的一个接口函数...

对信号进行多层分解和重构，进行多频率分析的源程序-The signal decomposition and reconstruction of multi-storey, multi-frequency analysis of the source

开发硬件电路需要用到液晶显示模块1602的用户必备。调试实验源程序第三部分。-Hardware needed to develop liquid crystal display module 1602 required the user. The third part of the experimental source code debugging.

在Proteu环境下的DS18b20测温软件与硬件设计.-Proteu environment in DS18B20 temperature measurement software and hardware design.

由MSP430F135做控制器的温度控制详细程序，经过实践验证，可放心移植。-MSP430F135 done by the temperature controller to control the detailed procedure, after practice, can be assured transplantation.

单片机驱动162芯片典型程序，简单明了。-Single-chip driver 162 chipset typical procedure, simple and clear.

基于IAR embedde workbench的MSP430原理的心电检测源码。实现手持心电检测-IAR embedde workbench based on the principle of the MSP430 ECG detection source. Realize handheld ECG detection

单片机的24C02读写程序,使用Keil c编译器测试正常。-the 24C02 microcontroller literacy, the use of Keil c compiler tests are normal.

一个凌阳DA转换程序可以产生正弦波，三角波-Sunplus a DA conversion process can produce sine wave, triangle wave

红外遥控器7461的接收程序 其中有显示和键盘驱动-7461 infrared remote control receiver procedures which display and keyboard

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.