SCM detection procedures are monitoring, communications, display, including one...

简单的12864（控制器ST7920）液晶显示模块并行和总线方式控制c语言源程序-Simple 12864 (controller ST7920) liquid crystal display modules in parallel and bus control c language source code

单片机c语言编程软件平台keilc使用说明。-Singlechip c language programming software platform for use keilc.

大值的驱动电压，否则会造成液晶模块的损坏。如果在低于或大致等于典型驱动电压时，观察到了显示屏上有色调的变化，即显示域的底色略深于边缘的颜色，表明液晶模块电源连接正确，可以进人下一步工作。如-Large value of driving voltage, otherwise LCD module can cause damage. If less than or roughly equivalent to a typical drive voltage, the observed screen has color changes, which indicates that the domain a little deep background color at the edges, indicating that the LCD module power supply connections are correct, you can enter the next step. Such as

这个程序用于单片机和无线传输芯片CC2500之间的传送，包括发送，驱动，接收等完全的程序-This procedure for single-chip and wireless transmission between the CC2500 chip, including the transmission, drive, receive a complete program, etc.

1602的详细讲解，DATASHEET 和KEILC51的原码，可以作为参考-1602 of detailed briefings, DATASHEET and KEILC51 original code, can be used as reference

该源码采用标准c编写，使用SPI方式访问SD卡。-c prepared using standard, the use of SPI mode visit the SD Card.

atmega16 用pwm 产生正弦波 示波器观察ok-ATmega16 generate sine wave using pwm oscilloscope observation ok

C51 HD7279源代码,在项目上应用过.-C51 HD7279 source code applied in the project.

ZLG7289测试程序，用于调整你的程序，网站上下载的程序不能正常显示，使用ATMEL公司的Atmega单片机-ZLG7289 testing procedures used to adjust your procedures, site to download the program should not display properly, use the ATMEL ATmega company

关于msp430单片机的一些 自己收集的一些有需要的请下载-MSP430 MCU on some of his own collection of some of those in need, please download