tm1668程序

针对立于泰开发板的嵌入式开发文档，给初学嵌入式的人更多资料！-Thailand for an embedded development board to develop a document for learning more information embedded!

LPC2200系列的RAM测试程序，已改进，当RAM有故障会，急声报警；正常这按心跳频率发声。 改地址也可以用来有效测试FLASH-err

基于LPC2468的嵌入式系统开发板，可做项目是参考。-LPC2468-based Embedded System development board, to do the project reference.

STM32arm下位机HID程序，主机识别到设备，下位机控制上位机的鼠标，控制鼠标移动。

该代码是FM1702芯片的驱动程序源代码，已经测试通过，可以放心参考。-The code is the FM1702 chip driver source code, has been tested, you can rest assured reference.

This a simple bootloader for AT91SAM7{S,X}{64,128,256} processors. It permits you to download new code to the device over USB. This bootrom is installed at address 0x00000000 in the ARM, which means that it is the first piece of code to execute after reset. At startup, it waits for a few seconds to see if the downloader is trying to connect. If not, then the bootloader gives up control and jumps to your program. If the downloader is trying to connect, then the bootloader receives the new program over USB and writes it into flash.

S3C2440的中断处理部分，已调试通过，起码串口和网卡都已OK-S3C2440 part of the treatment interruption have been debug through, at least the serial and network card are OK

四路寻迹传感器有信号(白线）为0  没有信号（黑线）为1四路寻迹传感器电源+5V GND 取自于单片机板靠近液晶调节对比度的电源输出接口关于单片机电源：本店驱动模块内带LDO稳压芯片，当电池输入最低的电压6V时候可以输出稳定的5V分别在针脚标+5 与GND 。这个电源可以作为单片机系统的供电电源。

一份对nandflash ks9f1208读写操作的源代码 本人已经测试通过-A nandflash ks9f1208 read and write operations on the source code I have tested

dspic例程可以参考一下，国人风格与国外的风格-dsPIC routines for reference, people with foreign-style style