密码引爆器 输入正确引爆 错误发出警告 可仿真

ad0831模数转换必须，很哟用的，我也是找了好久哦，大家一起分享把！-ad0831 analog-digital conversion necessary, the very yo, I was looking for a long time, oh, we put together to share!

该程序用于控制电机的速度,通过占空比PWM来实现该功能.-The program used to control motor speed and PWM duty cycle to achieve through this feature.

关于来电识别的程序-on caller identification procedures

c8051f单片机支持软件读写flash操作例程与相关资料，使得能过无需外接eeprom等存储器，就能保存非易失性数据（掉电不丢失的数据）。-c8051f MCU support software routines to read and write flash operation with relevant information, It would make no such external eeprom memory, we will be able to preserve nonvolatile data (power-fail without loss of data).

用Keil　C51写的步进电机驱动程序。-Keil C51 was made with the stepper motor driver.

IO口模拟串口，c语言编写，使用一个定时器中断-Serial IO mouth simulation, c language, the use of a timer interruption

P1口为数据口,控制线在P3部分端口,详见...C-C++flashled.rar - flashled演示,用keli c与protues仿真得到。,,C-C++下一页... -P1 population of population data, the Line of Control in P3 some ports, See ... C-C flashled.rar- flashled demonstration. and c with keli protues simulations. , And C-C Next ...

ACEXT1K30最小系统的原理图和成熟PCB版图，可以直接拿到PCB制作厂商制作。同时也提供了与你自己定义的系统的接口，方便你将ACEXT1K30直接嵌入到你的系统中，而不需要再做其他的工作了-ACEXT1K30 the schematic and PCB layout mature, can be submitted directly to the production of PCB manufacturers produced. Also provided with your own definition of the interface, you will facilitate ACEXT1K30 directly embedded into your system without the need to do the work of the other

这是msp430与1335的接口控制程序，控制320*240的液晶显示驱动。-This is the MSP430 with the 1335 interface control procedures, control 320* 240 LCD display driver.

MSP430 F149的单片机 TimerA驱动程序，便于相应计时器的操作-MSP430 F149 microcontroller TimerA drivers, to facilitate the operation of the corresponding timer