飞利浦提供的I2C参考程序。共P87C591使用。

用CY7c6300驱动LED的源程序,经过验证,绝对能用P0口LED到VCC就可以.-with CY7c6300 drive LED source, proven, I absolutely can use P0 LED VCC to be.

MSP430系列汇编指令集,作为编程时或初学时使用-MSP430 instruction set compilation series, as a beginner programmer or the use of

1.将P1.0～P1.3接开关，将P1.4～P1.7接发光二极管。依据P1.0～P1.3开关状态控制P1.4~P1.7发光二极管点亮。 2.将P1.0～P1.7全部接发光二极管，开始P1.0、P1.5点亮，左循环50次后P1.1、P1.4点亮；右循环30次，循环往复。-1. P1.0- P1.3 will then switch to P1.4- P1.7 access LEDs. P1.0- P1.3 based on state control switch P1.4- P1.7 LED lights. 2. P1.0- P1.7 will take all LEDs started Schematic, P1.5 lit, the left circle after 50 P1.1 and P1.4 lit; Turn right circle 30 times repeated.

GPS开发，单片机接受代码，对于使用者非常重要-GPS

RS422 RS485技术标准-RS422 RS485 technical standards

三。对于进入密码锁的钥匙，假设复位后8个LED全亮，并使用sw1、sw2、sw3 3，然后sw2-> sw1-> sw3-> sw1，则表示解锁右侧会导致8个LED全暗。

RT12864M汉字图形点阵液晶显示模块，可显示汉字及图形，内置8192个中文汉字（16X16点阵）、128个字符（8X16点阵）及64X256点阵显示RAM（GDRAM）。 主要技术参数和显示特性: -RT12864M characters dot matrix graphics LCD module can display characters and graphics, built-in 8192 Chinese characters (16X16 dot matrix), 128 characters (8X16 lattice) and 64X256 dot-matrix display RAM (GDRAM). Main technical parameters and display characteristics:

BU2614 PLL 源程序,直接解压-source code for digital tuning system using BU2614 PLL IC. Please unzip directly.

该文件里包含了大量的常用经典的程序代码,可以为51编程者带来事半功倍的效果,-The document contains a number of popular classics code can be programmed for 51 brought a multiplier effect,

利用89S51单片机，通过DS18B20温度传感器测得当前的温度值，再送入4位8段数码管显示-Using 89S51 microcontroller, temperature sensor, through DS18B20 measured current temperature value, and then into four 8 digital tube display