use language to achieve the agreement of the source C8051FTCP/IP

关于SPLC501C的液晶编程，实现了中文菜单形式，可以参考-SPLC501C LCD on the programming and realized the Chinese menu form, they can refer to

democode.cpp是模拟器的主程序参考代码。用户可以通过它了解移植腾凌智能数字中文输入法需要做那些工作。-democode.cpp simulator is the main program reference code. Users can understand it transplant Tang Ling Intelligent Digital Chinese input methods need to do those jobs.

this a store management system-this is a store management system

ts1620液晶的驱动 24c02 红外遥控器 1302的驱动-ts1620 LCD driver 24c02 1302 infrared remote control drive

串行大容量存储器的c51 读写源程序特点：占用io口线少，缺点：读写时间比并行时间长-Serial large memory read and write the source decoder features : io occupied mouth lines, shortcomings : reading and writing than parallel long time

通过DS18B20读取温度（范围-55C~125C，精确到小数点后一位），通过4位数码管显示出来。 当温度为正且百位为零时，不显示，当温度为负时百位显负号。当温度百位和十位都为0时0都不显示。-Read through the DS18B20 temperature (range-55C ~ 125C, accurate to one decimal), through four digital tube display. When the temperature is zero and 100, do not show, when the temperature is significantly negative at minus 100. When the temperature is 100 and 10 are not displayed 0:00.

51单片机方面的程序 用汇编写的 很经典的一些程序-51 SCM procedures used to write the classic compilation of some of the procedures

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

3字节4字节浮点数转换程序，用来解释单片机的浮点数-3 bytes 4 bytes float switching procedures used to explain SCM float

用于CAN源代码.rar的头文件,一个不错的例程.-for source code. Rar the first document, a pretty good routine.