arm7 LPC2136的Keil for arm 工程模板，包含了uCOSII操作系统。对Keil编译环境熟悉的单片机开发人员非常具有参考价值。-arm7 Keil LPC2136 the arm for the project template, uCOSII operating system contains. Keil compiler to the environment familiar microcontroller developers have great reference value.

整个控制过程中最关键的部分是与PC和终端的通讯过程。有关两方面通讯的详细的协议参见PC和终端的文档-51

51单片机播放音乐的C51程序和用Proteus仿真的电路图，上述两个软件均已上传，请站长慎查-51 Singlechip play the music of C51 process and circuit simulation with Proteus, the two have been upload software, please check station Shen

35个51单片机使用的c51程序，在keil 环境下开发-35 51 Singlechip C51-use procedures, the development environment in keil

PCF8563 时钟芯片驱动 89C51 -PCF8563 clock chip driver 89C51

本程序采用AT89C51单片机，ADC0809模数转换芯片进行模数转换，最终由数码管显示“0809**”。-This procedure using AT89C51 single-chip microcomputer, ADC0809 analog-to-digital conversion chip for analog-digital conversion, and ultimately by the digital tube displays

单片机应用程序集，含PIC elong 等-SCM application sets, as with PIC elong

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

msp430单片机与dsp的同步通信及传输过程中的显示及编码-MCU and DSP Controller of synchronous communication and transmission process of coding and show

内置T6963C的液晶图形模块的详细资料-Built-T6963C Graphic LCD Module details