毕设使用的背景布谷鸟搜索算法例子

matlab pdf it is use for the project how to do using different steps.

汽轮机转子系统前三阶临界转速的传递矩阵法(Turbine rotor system critical speed before the third-order transfer matrix method)

Full Wave Rectifier This demonstration illustrates use of the Ideal Switching Device solution method to simulate a full wave rectifier using ideal diodes.

这是TD算法的逆过程，首先将时间序列，划分为相邻点的短序列，当然此时的拟合误差为0，因为第一点和第二点的连线，原始点都落在线段上。将相邻两个线段连接起来，此时每条线段包含三个原始点，计算中间那个点的拟合误差。这样，所有这些三个点的线段中的中间点的拟合误差计算出来后，找出误差最小且误差小于阀值R的分段，作为第一条包含三个点的线段。 在上面的基础上，第一条分段同样的和相邻线段连接，然后计算每一条分段的拟合误差，再找出误差最小且小于阀值R的分段，作为第二个分段。依次方式循环，直到所有分段的拟合误差都小于阀值R，分段结束。 (This is the reverse process of TD algorithm, the first time series is divided into short sequences adjacent dots, of course fitting error is zero at this time, because the first and second points of connection, the original point fall line on. The two adjacent segments are connected, then each segment contains three original point, the intermediate fitting error calculated that point. Thus, after all these segments fitting error of three points in the intermediate point calculated to find the minimum error and the error is less than the threshold R segment, as the first line contains three points. Based on the above, the first segment and the adjacent line segment connecting the same, and then calculate a fitting error for each segment, and then find the smallest error and less than the threshold R segment, as the second segment . Followed by a cyclic manner until all segments fitting error is less than the threshold R, segment ends.)

说明：  使用波动方程有限差分模拟瑞雷波的传播，包括模拟和成像，可以更改检波器位置信息(surface wave modeling and display)

相参脉冲串复调制信号，一些自适应信号处理的算法，虚拟力的无线传感网络覆盖，实现六自由度运动学逆解算法，迭代自组织数据分析，包含光伏电池模块、MPPT模块、BOOST模块、逆变模块。

matlab书，对基本算法，波形处理，仿真工具，系统控制有详细介绍，特别是对各种工具的介绍很全(matlab book, the basic algorithm, waveform processing, simulation tools, system control has a detailed introduction, especially for the introduction of tools is very wide)

source code for direct sequence spread spectrum

说明：  Mimo-noma论文复制+代码运行通过，结果是可用的，但你必须下载CVX工具包(Mimo-noma thesis replication + code runs through, results are available, but you have to download the CVX toolkit)

一些自适应信号处理的算法，MIMO OFDM matlab仿真,相关分析过程的matlab方法，采用偏最小二乘法，线性调频脉冲压缩的Matlab程序,利用matlab GUI实现的串口编程例子。