ARM得编程实例。很经典。在win ce5.0环境下的编程实例

arm 指令集的详细解析 对于adi平台的嵌入式芯片内部有微指令集的芯片，这个文档是很有价值的-arm instruction set for the detailed analysis of Patrick platform chip embedded within the task of the chip sets, this document is of great value

STM32微处理器的固件库 STM32微处理器的固件库 -STM32 firmware library microprocessor microprocessor STM32 firmware library

hjtag很详细的使用文档出自twentyone的手笔，下载看一下很有帮助，帮助你使用这个功能很强大的软件进行调试开发-the document of htag is very useful its writed by the author of hjtag tentyone so read it and have fun

ARM7―LPC2124―I2C开发实例 基于Keil uVision3源码开发再进行Proteus 7 联合对ARM7―LPC2124―I2C硬件电路仿真-ARM7-LPC2124-I2C Development Keil uVision3 source code examples based on the development of further joint Proteus 7 on the ARM7-LPC2124-I2C hardware circuit simulation

彩色OLED,stm32f10x. 实现画点，画圆形.暂无字库.lcd led oled液晶显示驱动程序

STM32的USART详细例程，能够使用的，下载完了要给点回复哦！-STM32 detailed the USART routines, can use to download the end-point to give back Oh!

采用ks0108或者兼容芯片的128*64点阵液晶屏驱动程序-Ks0108 or compatible chips using 128* 64 dot matrix LCD driver

spi总线驱动，在8bit mcu上调试通过。 spi总线控制方便，效率很高。

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4,每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

arm的一些程序,对于新手很有用的,很不错-arm some of the procedures for newcomers very useful, very good