This is the start loading code

三星S3c2410 的 GPIO控制程序. GPIO的控制是所有嵌入式开发的基础,GPIO掌握了,才能再磁基础上深入. -of GPIO control procedures. GPIO control is all embedded development base Hence, the GPIO master, can we further on the basis of magnetic-depth.

Basic project for incubator (Thermo+regulator)-Basic project for incubator (Thermo+regulator)

基于ARM的应用Source3，在网上找到的源码，分六个，这个是3-ARM-based application Source3 the Internet to find the source code for six hours, this is 3

JTAG协议分析软件,配合周立功的LA1032逻辑分析仪使用,可以观察各种JTAG仿真器的通信过程.-JTAG protocol analysis software, with Zhou meritorious LA1032 logic analyzer use, can observe various JTAG Emulator for the communication process.

本人写的用与mega8单片机，由CodeVisionAVR编译通过的产生pwm波的小程序-I write using mega8 microcontroller, CodeVisionAVR compiled by the waves generated by small pwm procedures

这是C8051F020单片机读、擦、写串行EEROM芯片M25P40(4M)的驱动程序。全部为自己根据25p40的datasheet编写的，都能够成功使用。M25P40容量大，价格便宜，SPI接口，与8051单片机接口方便。-this is the driver of C8051F serial MCU to the EEROM chip M25P40.

基于ARM7的嵌入式微处理器LPC2131对LED进行控制，即GPIO的使用-based on the ARM7 LPC2131 right embedded microprocessor control LED, that the use GPIO

lcm显示代码.用于1602的液晶原代码.测试已经通过.-lcm display code

ARM S3C44B0X的AD 接口实验-ARM S3C44B0X AD Interface Experiment

jtag 和 ARM9 的编程源码-JTAG programming and ARM9 FOSS