结构化的I/O处理的Atmel AVR ATmega

这是一个基于金蝶K/3的磅秤插件源代码。安装本差价需要金蝶K/310.0以上的版本。本插件是客户端程序。在车辆过磅时自动产生金蝶K/3的出库单。-This is a based on Kingdee K/3 plug-in source code of the scales. Install this post needs more than Kingdee K/310.0 version. This plug-in is the client program. When weighed in the vehicle automatically generated Kingdee K/3 of出库单.

SAM9261 BasicMMU Example code with ADS1.2 (163 kB) The goal of this project is to show how to use a PC100 SDRAM and the MMU to perform a rating with a 100MHz Bus Clock. The rating is based on Dhrystone 2.1. It shows the rate when I+D Caches are disabled or enabled, with or without MMU and I Cache is disable or enabled, with or without MMU. -SAM9261 BasicMMU Example code with ADS1.2 (163 kB) The goal of this project is to show how to use a PC100 SDRAM and the MMU to perform a rating w praxiology a 100MHz Bus Clock. The rating is based on Dhr ystone 2.1. It shows the rate when I Caches are d D. isabled or enabled, with or without MMU and I Cache is disable or enab led, with or without MMU.

本程序是显示模块的例程，所接器件为四位八段led数码管，其中PTB0-PTB3 与数码管的位选相连接，PTB4，PTB5与74LS164连接确定你开发板上拨码开 关JP1（图片上的12）的两位和JP4（图片上的9）的5、6、7、8位处于on）， 而其他位处于远离on！-This procedure is the routine display module, the access device for four eight led digital tube, which PTB0-PTB3 bit digital tube and connected to the election, PTB4, PTB5 with 74LS164 sure you connect the development of on-board DIP switch JP1 ( picture on the 12) two and JP4 (picture on the 9) of 5,6,7,8 located at on), while the other located at far away from the on!

嵌入式C程序员面试指南，详细说明了嵌入式C程序员必须具备的那些技能和面试技巧，是嵌入式C程序员面试的必经之路文档。。。

启动“新建项目向导”，并在收到请求时添加所有程序集（*.asm），

Sample Application using Keil 8051

S3C3440的spi裸机驱动程序，开发板是YC2440F-V5.1，该程序用于接收TDC的测距结果-S3C3440" s spi driver development board is YC2440F-V5.1, the program used to receive the results of TDC ranging

这是一称的项目原文件,包括T9汉字输入,打印机,24C512,已经引用到产品上-This is a project known as the original documents, including T9 inputting Chinese characters, printers, 24C512, has been applied to products

测温控制系统(C程序)，使用51单片机实现测温控制的系统，用c语言编制而成。-Temperature control system (C program), the use of 51 single-chip realization of temperature control systems, prepared using c language.

ACN协议 Artnet协议 DMX512-A 调光网络-ACN agreements Artnet protocol DMX512-A lighting network