继续上传：单片机89C51，LCD12864菜单程序。

其他人需帐号就可下载此源码液晶显示12864-Take account of other people can download this source LCD 12864

用51单片机控制温湿传感器dht11的程序 汇编语言编写-With 51 single-chip microcomputer to control the process temperature and humidity sensors dht11 the preparation of assembly language

真正的PICC函数中文介绍！是购买ICD2时候赠送的正版内容-PICC real function introduce Chinese! Is the time to buy ICD2 gift of genuine content

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

PC - MCU 串行通迅程序 单片机接收主机的数据,然后将数据传送到P0口, 并传回给主机 当按下AN1时, 单片机发送字串给主机-PC-MCU serial communications procedures SCM receive mainframe data, and data transmission to the P0 mouth and passed back to the mainframe when pressed AN1, SCM string sent to the mainframe

usb slaver for sd card

交通灯,可控制行人过马路的时间,有protues图和c语言程序-Traffic lights, pedestrian crossing the road to that time, protues map and c language program

AVR单片机读取坐标。 项目中使用过，相当有价值的代码。-AVR read coordinates. Items used very valuable code.

一种采用CYPRESS的PSOC混合信号控制其系列的智能型充电器设计方案，可支持多种电池理性，根据电池充电曲线进行调整，开发IDE为CYPRESS的PSOC Designer，硬件为PSOC。-use of a PSOC mixed-signal control of its series of smart charger design that can support multiple battery rational, battery charging curve adjustment, IDE for the development of the PSOC Designer CYPRESS, hardware PSOC.

two wire smbus using uC