控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序....

Xilinx_Spartan3E开发板的常见疑难问题解答-Development board Xilinx_Spartan3E Common Troubleshooting

（个人原创）这个是我在Keil下写的MAX5532--MAX5535通用的驱动代码，由于我编写的时候，考虑到通用性，所以当你使用的时候，需要根据你的器件特性几乎不用修改函数提来调用我的函数模块（我在需要调用的注释和注意点已经写的很清楚了），缩短你的工程开发周期。-(Personal original) This is what I wrote in under Keil GM MAX5532 MAX5535 driver code, as I am prepared when taking into account the general, so when you use when you need to almost do not modify the device characteristics mentioned function to call I have a function module (I need to call attention to the comments and points have been written very clearly), and shorten your project development cycle.

C51单片机实现红外探测 可以探测是否有障碍物及入侵者 数据通过串口格式化 38 KHZ载波-C51 MCU infrared detectors can detect whether there are any obstacles and invaders through serial data format 38 kHz carrier

STK500_2下载器 M8 支持bootloader(带bootloader源码) 使用STK500_2 协议的ISP下载器，监控芯片 M8,数据通讯RS232.使用 ATMEL AVRStudio 4.xx STK500工具的进行软件升级。可通过ATMEL AVRStudio 4.xx STK500工具升级固件程序。升级方法：通过设定电压 即按“write voltage”按钮进入bootloader程序。 -M8 browser support STK500_2 download bootloader (with bootloader source code) to use the ISP to download STK500_2 agreements, and monitor chip M8, data communication RS232. Use ATMEL AVRStudio 4.xx STK500 tool for software upgrades. By ATMEL AVRStudio 4.xx STK500 firmware upgrade tool. Upgrade methods: by setting the voltage that is, according to

上位机采用vb编程,实现与多台s7200的自由口通信.-Host computer using vb programming, with more than the freedom of the mouth communication s7200.

LCD液晶显示驱动模块液晶显示计时时钟单片机源程序-LCD display driver module LCD MCU time clock source

CAN上位机通讯程序vb与单片机通信时用的上位机程序 -CAN PC communication program vb and MCU communication procedures used in PC

MSC-51 3字节和4字节浮点数计算程序，主要用于数据采集及上传，经过IEEE转换，在上位机直接显示-MSC-51 3-byte and four-byte floating point calculation procedure used mainly for data acquisition and uploads After IEEE conversion, the PC directly show

比较完成的FAT文件系统与单片实验,本系统利用AVR-Comparison of completed FAT file system and single-chip experiment, the system uses AVR

读取RF射频卡源代码（C51）-RF card reader source code (C51)