介绍了radon变换原理

说明：  动态矩阵双输入，有约束的条件之下进行仿真。(Dynamic Matrix dual-input, under the conditions of constrained simulation.)

the MATLAB codes for the well-known modulation techniques.

PARAFAC 用于多维数据分辨与校正(PARAFAC For multidimensional data resolution and correction)

介绍最大功率点追踪的变步长的算法和原理。(Describes the maximum power point tracking algorithm and variable step length principle.)

设计一个数字滤波器，在频率低于 的范围内，低通幅度特性为常数，并且不低于0.75dB。在频率 和 之间，阻带衰减至少为20dB。 (1)试求满足这些条件的最低阶Butterworth滤波器。(Design a digital filter, in the range of frequencies below the low-pass amplitude characteristic is constant, and not less than 0.75dB. Between the frequency and stop-band attenuation of at least 20dB. (1) Determine the lowest-order Butterworth filter to meet these conditions.)

matlab做的论文资料，从CNKI上找来的，这里免费给大家，希望对大家有用(MATLAB based on the double inverted pendulum control system design method, which died on the CNKI papers, fees, free of charge to everyone here, in the hope that useful)

cordic算法的matlab仿真，小波包分析提取振动信号中的特征频率，微分方程组数值解方法。( cordic matlab simulation algorithm, Wavelet packet analysis to extract vibration signal characteristic frequency, Numerical solution of differential equations method.)

这是一个利用维纳滤波方法进行消噪的MATLAB 程序，器效果比谱减法好在没有尖锐的噪声(it is a delete noise program.it is based on matlab)

介绍了模糊控制pid的一边编程思想，并给出了matlab的调用命令(Describes the fuzzy control pid side programming ideas, and gives the call to the command matlab)

”BP.m“文件是BP神经网络整个模型的源程序； “train.fig”是训练时最后得到的图片； “程序运行的人口数量原始数据.fig”是预测结果绘制的图； “程序运行时matlab命令窗口的内容.txt”是运行程序是在matlab命令窗口显示的东西； “程序运行完产生的数据.mat”是程序运行完毕产生的数据。 .bmp文件和.fig文件一样()