A barbecue pits of the ladder assembly line procedures, PLC Mitsubishi FX2N Seri...

BH1415F调频台控制C程序 使用AT89C52单片机，12MHZ晶振，用共阳四位LED数码管-FM BH1415F control C program uses AT89C52 single-chip, 12MHZ crystal, with a total of four positive LED digital tube

用89S52进行DS1820温度读取程序-89S52 used for DS1820 temperature reader

LCD显示模块C51源程序-C51 LCD display module source

一些常用的c51源码，编程时可以参考。-some frequently used source decoder, the reference can be programmed.

51单片机浮点数运算子程序及IEEE和51浮点数相互转换程序 -51 floating-point operations and subroutine IEEE floating point and 51 mutual conversion

非接触式IC卡读写器,Mifare 1非接触式IC卡读写核心模块MCM2-Design of Mifare Touch- Free IC Card Reader

功能：利用时钟芯片DS12887在LCD（LCM141）上显示时间，通过4×4键盘来修改时间，利用MAXIM232进行标准串口发送。4×4键盘中有数字键（0～9）和功能键（F1键为“→”，F2键为“←”，F4键为“发送”，设置键为“设置当前时间”，确定键为“把修改的当前时间写入到DS12887相应的存储单元中”）。 硬件：单片机为8K的98C52（ATMEL），LCD为北京青云的LCM141，标准串口总线为MAXIM的232芯片，时钟芯片为DS12887（DALLAS） -Function: the use of clock chip DS12887 in the LCD (LCM141) show time, through the 4 × 4 keyboard to modify the time and using the standard serial port to send MAXIM232. 4 × 4 keyboard in numeric keypad (0 ~ 9) and the function keys (F1 key for the

这是一个波形选择菜单，通过开发板上的按键，选择波形，幅度，频率的等各参数，然后发送给下位机。让其产生需要的波形。-This is a waveform selection menu, through the development of on-board buttons, select the waveform, amplitude, frequency and other parameters, and then sent to the next bit plane. The need to generate the waveform.

FX2开发板程序下载C -FX2 development board downloads C

大厦LED流水显示的程序，刚刚编完，可通过修改循环的次数和数据表来构成不同的显示效果-LED shows the procedure, the newly produced, cycle through changes in the number and composition of data tables show different results