atmelsam7s64驱动3310液晶屏源代码

本软件实现了FLASH底层驱动包括NOR FLASH与NAND FLASH-The software achieved a FLASH drive, including the bottom NOR FLASH and NAND FLASH

EasyARM2131开发板源码之一-----------6.GPIO输出实验-LED数码管显示0-F字符，同时控制LED1、LED2、LED3、LED4显示对应的16进行值-EasyARM2131 one source development board----------- 6.GPIO experimental output- digital LED Display 0-F characters and control LED1, LED2, LED3, LED4 shows the corresponding values for 16

This a simple bootloader for AT91SAM7{S,X}{64,128,256} processors. It permits you to download new code to the device over USB. This bootrom is installed at address 0x00000000 in the ARM, which means that it is the first piece of code to execute after reset. At startup, it waits for a few seconds to see if the downloader is trying to connect. If not, then the bootloader gives up control and jumps to your program. If the downloader is trying to connect, then the bootloader receives the new program over USB and writes it into flash.

AT91RM9200-U-Boot at91rm9200u-boot移植源代码，稍加修改你就可以使用。使用其他的片子的也可以参考。-AT91RM9200-U-Boot at91rm9200u-boot transplant source code, a little change you can use. The use of other films also reference.

XS128 经典12864液晶程序

一定要看看，ARM相关-must look at the relevant ARM

spi总线驱动，在8bit mcu上调试通过。 spi总线控制方便，效率很高。

/****************************************Copyright (c)**************************************************** **                               Guangzhou ZHIYUAN electronics Co.,LTD. 请点击左侧文件开始预览 ！预览只提供20%的代码片段，完整代码需下载后查看 加载中 侵权举报

整理了Autoquad源代码的所有程序，适合所有芯片使用，总共包含200多个函数，可以作为日常写程序的参考 有can，spi，pwm，ppm等常用函数

资源描述本代码基于c8051f410单片机为硬件核心，通过对芯片内部资源adc,uart0,timer等的有效配置和利用，完成一个简易的电压测量，并讲测得的电压值通过上位机的通信功能传送至上位机。