smartarm2200开发板上，minigui消息处理实验源程序

ucgui在gba上的移植-ucgui impressions in the transplant

完成在S3C2410处理器上移植μC/OS-II内核，然后实现以下多任务： a) 控制实验箱核心板上4盏LED灯轮流亮灭； b) 将LED1连接到ARM9-2410EP增强型实验箱扩展口的DA OUT端口，通过实验箱上的键盘（比如“↑”、“↓”键）控制LED1亮暗变化，同时在超级终端显示该控制值； c) 将LED2连接到扩展口的I/O输出口，通过超级终端按键控制LED2亮灭，即按一下PC的超级终端某个键（比如回车键）LED2灭，再按LED2亮，反复循环。 -Completed the processor S3C2410 transplant μC/OS-II kernel, and then multi-task to achieve the following: a) control experiment box core board 4 bright LED lights out rotation b) will LED1 connected to the ARM9-2410EP enhanced experimental me expansion of the mouth of DA OUT port, through the experimental box on your keyboard (such as

博创UP-NETARM2410-S实验箱源码：Exp3 DA接口实验-Fiberxon UP-NETARM2410-S experimental box source: Exp3 DA Interface Experiment

本文介绍了_C/OS-II概况和ARM体系结构中与移植工作相关的一些概念，并在此基础上分析了基于ARM的移植工作。-_C/OS-II Profiles and the ARM architecture and transplantation related to the work of some of the concepts, and on the basis of this analysis based on the ARM transplants.

这是基于arm的嵌入式操作系统基础性实验SPI实验，希望对大家有所帮助-This is based on the arm of the embedded operating system based on experiments SPI experiment, I hope all of you to help

基于嵌入式实时多任务操作系统ucos－ii的GUI的源码，精炼实用-Source code of GUI based on ucos-ii, very small and useful.

嵌入式操作系统ucos在51单片机上的移植，很有实用价值，参考这个程序也可以把ucos轻松的移植到其它mcu或arm及dsp上-embedded operating system in the SCM 51 transplant, useful, reference to this procedure can also CENTER easily ported to other mcu or on the arm and dsp

ucos for arm 1176 porting

uCosII For S3C44b0x ADS版本-uCosII For S3C44b0x version of ADS

LPC2300基础驱动库用户手册,CHM文档(LPC2300 based on database-driven user' s manual, CHM documents)