该程序比较好用容易修改，是一个单片机应用类的一个很好的程序。...

万年历挂钟智能系统设计开发环境为ICC,可以编译成汇编,直接下栽到嵌入式avr单片机进行控制-calendar wall clock intelligent system design and development environment for the ICC, can compile a compendium, Embedded directly to the downward avr microprocessor control

这是我在我们公司做的C51加油单片机程序-in our company do C51 microcontroller refueling procedures

PIC汇编语言样例程序集一，非常好的芯片驱动-PIC assembly language sample program sets a very good driver chip

1T单片机延时程序头文件代码，us，ms，s延时直接调用，无需再写-1T delay program header file code for MCU

基于80C51的一个例子程序,实现了流水灯操作-an example of the process and realized the water lights operation

AVR单片机使用U-IP库的例子，U-IP是一个简化的TCP/IP协议包，希望对有网络编程的嵌入式开发爱好者有用-AVR single-chip U-IP library to use the example, U-IP is a simplified TCP/IP protocol packets, and they hope to have network programming embedded development enthusiasts useful

C51单片机中文介绍-C51 microcontroller introduce Chinese

由单片机控制的蜂鸣器，唱出猪之歌的音乐，用C语言编的程序。-SCM control buzzer singing Song of Pig C-language program

TFT2.8 lcd +SSD1289 IC init-TFT2.8 lcd+SSD1289 IC init

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.