家电智能控制统一主机

zlg cf card for ucos

LUMINARY 看门狗代码（IAR开发环境）-Luminary watchdog code (IAR development environment)

状态1：正常时，8个LED发光二极管（彩灯）循环点亮。 • 状态2：有报警时，蜂鸣器发出报警声（用P3.3接一个按键，模拟产生报警信号。当开关合上，发生报警；当开关断开，报警停止。用P3.7输出音频信号驱动扬声器，作为报警信号），同时8个LED发光二极管（彩灯）闪烁。 P3.2接一个按键，用于消除报警-Status 1: normal, eight LED light-emitting diodes (lantern) light cycle.

想使用宏晶科技ＳＴＣ系列的ＣＰＵ可以下载本文件，方便编程 -want to use technology-crystal STC series of CPU can download the paper to facilitate programming

TLC548C, TLC548I, TLC549C, TLC549I 芯片的资料-TLC548C, TLC548I, TLC549C, TLC549I chip information

本装置是一个以HT46R71D 为主芯片，配合传感器组成的汽车轮胎气压检测装 置，最终取高三位有效值于LCD 显示，有四种显示单位供切换（Psi、Bar、Kpa、 Kgf/cm2）。本装置仅为参考范例，使用时，为提高准确度，建议多量测些组数 据来构建Sensor Output Voltage - Discharge Time (V-T)表格，并作相应校准。-This device is a HT46R71D-based chips, with sensors detecting vehicle tire pressure devices, and ultimately take the high-three RMS in LCD display, there are four types of display units for switching (Psi, Bar, Kpa, Kgf/cm2). Only reference to an example of the device, when used to improve the accuracy of the proposed多量measured set of data to build more Sensor Output Voltage- Discharge Time (VT) forms, and the corresponding calibration.

led源程序，51负则led，然后编译发光二极管.asm摊位，本来会领一个走出黑暗的结果

语音小车电路图 用凌阳单片机做的 语音小车电路图 用凌阳单片机做的

基于80C51和CH375的实现USB打印机驱动器的设计与实现方法-Based on 80C51 and CH375 realize the USB printer driver design and implementation

DS18B20.C(一般通用的数字温度传感器)完成代码,可直接使用.-DS18B20.C (general use digital temperature sensor) the completion code can be used directly.