8051 Series Single

ST7787 驱动程序，比亚迪2.4inch的LCM驱动程序，初始化代码-ST7787 driver, the LCM BYD 2.4inch driver initialization code

本源码实现了在下位机上对室内温湿度的监控，对外接设备电压欠压的监控，以及室内火警监控-Realize the source of the next-bit machine on the indoor temperature and humidity controls, external voltage under-voltage monitoring and control equipment, as well as the indoor fire monitoring

用L293步进电机驱动芯片做的步进电机驱动器.-Stepper motor driver using L293 chip to do the stepper motor drive.

用LPC93251操作nand flash K9F6408，能正确擦，写，读。改用其它芯片，方法类似，注意时序就行了。如换用大容量flash，请注意每块的页数，6408每块是16页的。-with LPC93251 operation nand flash K9F6408 can correct rub, writing and reading. Other chip switch, a similar manner, the attention on the timing of the trip. If used for large-capacity flash, to every piece of pages, 6,408 each block is the 16.

x5045的应用程序，多初学的朋友很有帮助！-X5045 applications, and more helpful beginner

MCS-51单片机应用设计-MCS-51 Application Design

luminary系列单片机基础源码模板，大家可以直接试用-luminary Series MCU-based source code template, you can try

串行IIc总线型EEPROM24c02的读写汇编源程序，并由按键控制读写操作。-Serial Bus type IIc EEPROM24c02 compilation of source code to read and write, and write control buttons.

红外线接收程序,本程序运行在NEC制下的遥控器下-Infrared receiver program, the program is running in the NEC remote control system under

之前看过论坛上有一个C8051和S3530A的通信程序，但我认为很复杂而不具有通用性，我自己写的一个3530通过I2C总线与单片机的通信程序,虽然很短,但是很实用.-Read before the forum have a C8051 and S3530A communications procedures, but I think very complex and not universal, and I wrote it myself a 3530 through the I2C bus communication with the SCM process, although very short, but very practical .