这个程序是用MSP430写的chipcon公司的无线收发芯片CC1100的驱动程序。...

单片机实现直流数控稳压电源,可调电压为0-9.9伏,步进为0.1伏,可以自动扫描键盘以增加或者减少电压-MCU NC Regulators DC power supply with adjustable voltage of 0-9.9 volts, stepping to 0.1 volts, can automatically scan the keyboard to increase or reduce the voltage

I2C串行总线元器件标准驱动程序的编写，可自己定义串行时钟线和串行数据线所在口-I2C serial bus driver standard components of the preparation, may own definition serial clock line and serial data line I

采用IAR在线调试ADI基于ARM7内核的ADUC7026的RAM_CODE-IAR debug using online ADI based on ARM7 core ADUC7026 the RAM_CODE

本课题所研究的可存储虚拟示波器定位为低档型，即在性能上只需满足大多场合的基本应用，努力实现小型化，价格尽可能低廉，这样在财力有限的小用户（电子爱好者、小型企业）中能够普及，在大用户的使用中发挥便携性强的优势，与高档示波器配合使用，互相取长补短。-Studied this subject can be stored as a virtual oscilloscope-type low-grade, that is, in terms of performance on most occasions, only to meet the basic application, and strive to realize miniaturization and low prices as much as possible so that limited financial resources to small users (electronic enthusiasts, small enterprises) can be universal, in the use of large users to play a strong advantage of portability, high-end oscilloscope used in conjunction with each other.

一个单片机控制步进电机的经典例子,KEIL下直接编译,用PROTEUS仿真,欢迎大家下载!-A single-chip stepper motor control of the classic examples, KEIL compiler directly using PROTEUS simulation, welcomed everyone to download!

一个单片机心电图数据采集带通滤波的算法。-ECG data acquisition of a single-chip band-pass filtering algorithms.

急救车与交通灯）（1）南北与东西方向，每个方面由红黄绿三个灯控制（2）南北向：　红（30秒），黄（5秒），绿（25秒）　　　东西向： 红（35秒），黄（5秒），绿（25秒）　　　上述基本参数可以根据实际情况自行调整，灯的变化规律与实际路口规律相同，绿灯在最后5秒钟时，黄灯亮，然后红灯亮，不允许两个方面同时亮绿灯。（3）绿灯的时间显示在数码管上进行显示。（4）可以通过一个开关控制，当开关信号为0时，整个交通灯全灭提高要求：（1）设计一个紧急控制开关信号，当紧急开关信号为1时，两个方向的灯全为红灯。紧急开关撤消后，按照开关按下之前的状态继续运行（其参数要保存）。（2）设计一个夜间行车开关，当开关按下后，两个方向都只有黄灯闪烁，其它灯熄灭。（3）设计两个方向的亮时时间可调。-emergency vehicles and traffic lights) (1) North and South and east-west direction, each with three yellow-green from red lights control (2) to the north and south : red (30 seconds), yellow (5 seconds), Green (25 seconds) to things : red (35 seconds), yellow (5 seconds) Green (25 seconds) above basic parameters can be adjusted to the actual situation, the light changes with the actual law of the same intersection, the green light in the final five seconds, the yellow light is on, and then a red light, bright, not two fronts simultaneously bright green. (3) the green light at the time displayed on the digital display control. (4) can be controlled by a

12位da转换程序，调试通过-12 da conversion process, debugging through

C51七种实用子程序集4-C51 seven practical subroutine Set 4