心电数据采集射频单

MSP430f2274单片机的ds08b20程序，实现4位小数显示，精确到0.0625度^-MSP430f2274 SCM ds08b20 procedures, to achieve four decimal display, accurate to 0.0625 degrees ^

用basic编写的t6963c控制器的液晶驱动程序。-t6963c display driver in basic.

dds 信号发生器的参考程序，，精工参考-dds reference signal generator procedures, Seiko reference

LT_1B msp430开发板例子程序－TA_12

ZLG MINIARM-N20源代码，大家可以参考下！-ZLG MINIARM-N20 source code, everyone can refer to the next!

利用单片机的定时器定时，令十字路口的红绿灯交替点亮和熄灭，实现主支路路口的交通信号灯控制（尽可能保持主线的畅通，即在通常情况下，保持主线的放行，只有在支线到达时，才放行支线），同时采用LCD显示倒计时时间及当前灯的状态-The use of MCU timer timing, so that the crossroads at the traffic lights turn out light and to achieve the main slip road junction traffic lights control (as far as possible the smooth flow of the main line, that is, under normal circumstances, to maintain the release of the main line, and only arrived at the branch only when the release branch), while using LCD display countdown time and the current state of light

单相电机变频驱动原码,采用DISPIC30芯片-Single-phase motor inverter drive the original code, the use of chip DISPIC30

这是一个基于C语言的单片机的步进电机的程序。它是通过改变相位来调节电机的旋转速度-This is a microcontroller based on the C language, stepper motor programs. It is by changing the phase to regulate the motor rotation speed

12864中文字库液晶演示程序 MS12864R 测试程序(串口) 连线表 CPU=89C52 SystemClock=12Mhz CS=P3.0 SCLK=P3.1 SID=P3.2 Reset=RC in Board

低电压检测. A口低8位接键盘列线，键盘行线接VDDIO；B口高8位接LED // 按K1键 低电压为2.4v // 按K2键 低电压2.8v // 按K3键 低电压3.2v // 按K4键 低电压为3.6v