LPC2103的第一个实验：流水灯，用proteus7仿真，C语言代码，在Keil3中编译，文件内已有完整的工程和仿真图了。...

用ADuC8xx单片机实现AD转换、DA转换、片内flashdata的操作、定时器、计数器和I2C通信的源码-with ADuC8xx MCU AD converter, DA conversion, Chip flashdata operation, timer, counter and I2C communications FOSS

按键控制步进电机正反转，此为电子显微镜载物台三维控制设计-Stepper motor control key positive

Ad9959源代码，包含各个引脚的功能图-AD9959，yudaima.baohajhjkj

* 功能：使用PWM6输出PWM信号，通过滤波电实现DAC转换。由KEY1控制PWM的占空比， * 每按一次按键将会改变一次PWM的占空比。 * 说明：使用示波器观察测试点PWM和PWMDAC。-* Function: Use PWM6 output PWM signal, by filtering electrical realize DAC conversion. Key1 controlled by the PWM duty cycle,* every time a button will change the PWM duty cycle.* Note: Use the oscilloscope to observe test points PWM and PWMDAC.

2008北京奥运会的倒计时牌的课程设计,3块数码管分别显示年月,时间,剩下的天数-The countdown to the 2008 Beijing Olympic Games licensing curriculum design, digital tube 3, respectively, show the date, time, number of days remaining

USBASP的源程序，里面有和USB通讯的例子-USBASP the source, there are examples and USB communications

16*64位点阵点 阵显示汉字程串口输出字符数据，P2口输出行扫描信号,P0_0输出595锁存信号-16* 64 dot matrix display Chinese characters lattice-serial output character data, P2 mouth output signal scanning, P0_0 595 latches the output signal

此文件是在ＤＯＳ环境下对交通信号灯进行的设计，完成了红黄绿灯的相互转换．-this document is in the DOS environment for the traffic signal design, the red and yellow green to complete the conversion.

使用W77e58读写PCF8563时钟芯片，包含所有的子函数，均可以直接使用。-Use W77e58 literacy PCF8563 clock chip that contains all of the subroutine, can be used directly.

一个单片机控制有刷电机的C代码-an MCU control of a motor brush C code