一个单片机控制有刷电机的C代码

用于单片机4*4键盘扫描，及数码管显示 -muc keybord and led display.

AVR单片机mega16的串口通信程序下载。-AVR Singlechip mega16 download serial communication program.

DS1820单芯数字温度传感器的基于805X单片机的C程序-DS1820 digital temperature sensor based on the 805X MCU C Program

51单片机示例程序，点亮一个灯，有助于刚接触单片机的朋友-51 Single-chip sample procedures, lit a lamp, will help刚接触Singlechip friend

采集端程序，可以搜所电信号，每次可以采集32个信号，可以用于检测信号好差。-acquisition software, can be found by the electrical signal that can be collected each 32 signal can be used to detect bad signal.

OCM4X8C液晶显示在凌阳单片机上的驱动程序-OCM4X8C in Sunplus LCD Single Chip Driver

这是一个430的延时程序，能够比较精确的延时n us,或者n ms-This is a delay of 430 procedures, can be more precise delay n us, or n ms

红外线遥控器按键检测程序. 通过检测两次下降沿之间的时间差判断接受到的数据位. 已经通过了测试,能够正确区分出32bit数据的遥控器按键键值. 具有数据重发功能,但是数据的重发有点频繁. 使用晶震频率为11.0592MHz,所有定时值都是基于这个频率计算. 占用很少量的CPU时间,使用了外部中断0接受数据,定时器0进行计数, 定时器1作为串口的波特率发生器(Band = 9600).-Infra-red remote control button detection program. By detecting falling edge twice to determine the time difference between the received data bit. Has passed the test, could correctly distinguish 32bit data button remote control key. With data re-issued, but data a bit of re-issued frequent. Zhenyuan frequency of use of crystal 11.0592MHz, all timing values are calculated based on this frequency. occupied by small quantities of CPU time, use the external interrupt 0 to accept data, timer 0 to count, timer 1 as a string port baud rate generator (Band = 9600).

C8051F020串口程序，波特率96-C8051F020 serial procedures, baud rate 9600

一个很好的例程，希望对您有帮助，欢迎探讨