非常好的软件程序

LPC2368 USBHID例程，加以详细的注释，可以方便有需要的朋友-LPC2368 USBHID routines, to be detailed in the Notes, to facilitate a friend in need

电压测试，数字电压表，利用动态显示模块显示-Voltage testing, digital voltmeter, using dynamic display module display

大家用单片机控制19264读DS1302吗？这样自己就可以很简单做一个万年历了哦・・・很有用，希望对大家开发有所帮助-MCU control 19,264 Reading DS1302? This itself can be very simple to do a hefty almanac oh useful, and I hope to help you develop

对MSP430片内温度传感器进行采样，输出温度到LCD * 程序使用单通道单次转换，温度显示的格式是华氏温度, * 带两位小数-On-chip MSP430 sample temperature sensor, the output temperature to the LCD* use single-channel single conversion, the temperature display format is Fahrenheit,* with two decimals

EM78单片机与24Cxx / 85Cxx 串行CMOS EEPROM接口I2C总线读/写的程序 ** （所有时隙均基于2MHZ晶体震荡器频率）-Tips SCM and 24Cxx/85Cxx CMOS Serial Interface I2C EEPROM Bus read/write procedures** (all slots are based on two MHZ frequency Crystal Oscillator)

基于AD9850/9851的数字信号发生器,调试通过，keilC51环境-AD9850/9851 based on digital signal generator, debug through, keilC51 environment

编译环境是KEIL,仿真环境是PROTEUS,控制彩灯的闪烁，利用51单片机，内含Keil C51教程可以使大，家了解彩灯的设计同时学习KEIL。-Compiler environment is KEIL, simulation environment is PROTEUS, control of the flashing lantern, using 51 single-chip, including Keil C51 Guide can enable the home to understand the design of lanterns at the same time learning KEIL.

lcd程序,1335控制器, 硬件平台：带sed1335LCD驱动器的320*240LCD模块,ads7846伟福仿真机， 软件平台: Keil v6.12 时间： 2004年6月3日-LCD procedures, 1335 controller, hardware platforms : sed1335LCD belt drives 320* LCD module, ads7846-fu simulator, software platforms : Keil v6.12 Time : June 3, 2004

控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序.-Control motor movement, G code program, if the G code is not clear, please understand G code, and then look at the procedures.

使用AVR单片机控制的温控与定时,时间从0至99小时99分99秒,温度从-55度到99度.-AVR single-chip microcomputer to control the use of temperature control and timing, the time from 0-99 hours 99 minutes 99 seconds, temperature from-55 degrees to 99 degrees.