智能巡线绕障小车的设计，采用51单片机，超声波测距。

HT1621驱动程序~~内带清屏，和4为自加1显示（3COM ，1/2偏压）-HT1621 driver ~ ~ within the zone clear screen, and 4 plus a self-display (3COM, 1/2 bias)

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

LT_1B msp430开发板例子程序－TA_15

FlashFlex51单片机

用单片机对24c02进行读写操作。简单易懂。适合初学者使用。-With the 24c02 microcontroller for read and write operations. Easy to understand. Suitable for beginners.

通过控制步进电机的驱动板来控制步进电机实现阀门流量的恒定，可作为反馈系统的参考-By controlling the stepper motor driver board to control the stepper motor to achieve a constant flow valve can be used as a reference feedback system

240x128液晶驱动程序（T6963控制器）-240x128 LCD driver (T6963 controller)

本文介绍了AT89C2051单片机的性能和特点，并在分析了超声波测距原理的基本系统框图。该设计系统经校正后，其测量精度可达0.1米-This paper introduces the AT89C2051 performance and features, and the analysis of the ultrasonic distance measurement principle diagram of the basic system. The design of the system calibration, measurement accuracy of 0.1 meters

AT89C5131的接口驱动-AT89C5131 Driver Interface

基于凌阳系列单片机的LCD701液晶驱动程序，已在SPCE61上调试通过-Sunplus based MCU Series LCD701 LCD driver, has been adopted in SPCE61 debugging