单片机控制步进驱动，S1为启动，S2为停止，S3为加一，S4为减一...

c51语言的93C46驱动程序-93C46 Driver

此程序实现"看门狗"WDT的功能*/此程序实现"看门狗"WDT的功能*/

crc 51 单片机计算程序，保证51利用串口通讯的可靠传输-crc 51 single-chip computing

我做的关于锅炉运行状况采集的产品，包括原程序及详细注释-I do on the boiler situation collection of products, including the original procedures and detailed notes

Protel 99中的快捷键 非常好用 -Protel 99 in very handy shortcut keys

用C51单片机实现的无线数据传输例程,注意此程序为发送端程序,需要接收端给予配合-MCU with C51 wireless data transfer routines and procedures to the attention of this software, the need to cooperate receiving end

利用中文字型点矩阵控制器ST7290编写的清屏,移动光标等函数-The use of Chinese fonts dot matrix controller ST7290 clearance preparation screen, move the cursor and other functions

周立功的EazyARM2200的模板，里面还有ucos的模版，还有ARM和Thumb两种模式下的模版-Ligong EazyARM2200 weeks of the template, there is also uCOS template, there are two types of ARM and Thumb mode template

* 硬件结构： PA0-5对应６个ＬＥＤ数显管的位 ，PC0-7对应各ＬＥＤ数显管的段 ，PB4-7为键盘。 * 软件描述： 上电后，时钟从00.00.00（时/分/秒）自动走时，在走时状态时 ， 按PB4（设定 * 键）超过3秒可循环选择调整时间/工作参数 ，接着按PB5以确定选择的操作 ，进入调整操作后 ， * 按PB5选择欲调整参数，按PB6（增加键）完成调整参数操作 。按PB7，进入时控运行，PB1亮， * 再按PB7停止时控运行，回显走时。在定时到时，PB0点亮。- * Hardware architecture: PA0-5 corresponds 6 LED numbers to reveal the tube the position, PC0-7 corresponds each LED number to reveal the tube the section, PB4-7 is a keyboard. * Software description: After on electricity, clock from 00.00.00 (when/a minute/second) is in luck automatically, when is in luck the condition, according to PB4 (hypothesis * The key) surpasses for 3 seconds to be possible to circulate the choice time/operational parameter, then presses PB5 by to determine the choice the operation, after enters the adjustment operation * Wants according to the PB5 choice to adjust the parameter, (increases key) according to PB6 to complete the adjustment parameter operation.According to PB7, enters when controls the mov

电压测试，数字电压表，利用动态显示模块显示-Voltage testing, digital voltmeter, using dynamic display module display