关于msp430f21xx每个模块的代码，可以放心的大胆的

这是一个单片机键盘响应程序，主要用于单片机设计中对键盘的编程，使得单片机能够显示键盘的按键-This is a microcontroller keyboard response procedures, mainly for the design of single-chip microcomputer keyboard programming, SCM makes the keyboard can display buttons

proteus例子,一些简单的proteus应用,对于初学者很实用-Proteus example, Proteus some simple applications, very useful for beginners

avr单片机EEPROM读写程序 经过调试，已经成功进行读写-avr after single-chip EEPROM read and write debug procedures have been successfully read and write

在89C51上操作小型LCD,显示汉字,字符和图案,字库放在EEPROM-operating small LCD display Chinese characters, characters and design, font on EEPROM

一种单片机双工无线串行传输方案,格式为ｗｏｒｄ-A single-chip wireless duplex serial transmission program, the format for word

93C46读写程序 很不错的程序希望和大家一起交流-93C46 literacy procedure very well and we hope that the procedures together exchanges

单片机最小系统，两位LED数码管由串口输出接两个164驱动，Lout,Rout为左右声道输出，SET， ALT0， ALT1为三个按键，也可自己在开始的I/O定义改成你想用的I/O口；12M晶振，若用89C51则只可装下约14首歌曲，用89C52则可装下近40曲-The smallest single-chip system, the two LED digital tube by the serial output driver 164 then two, Lout, Rout output for the left and right channels, SET, ALT0, ALT1 three buttons can also be their own at the beginning of the I/O definition change you want to use the I/O port 12M crystal, if one uses a 89C51 only loaded about 14 songs can be loaded with 89C52 under near 40

* 功能：运行RTC进行计时，将所时间值不断的通过串口向上位机发送，并把秒的值输出数码管D1 * 上显示。上位机运行EasyARM软件，在串口发送/接收窗口观察。 * 说明：* 通讯波特率115200，8位数据位，1位停止位，无奇偶校验。-* Function: RTC to run for a time, the time value will be constant upward through the serial-bit machine to send, and seconds values D1* output digital tube display. PC running EasyARM software serial port to send/receive window of observation.* Description:* 115200,8 bit baud rate of communication data bits, 1 stop bit, no parity.

用单片机控制max7219做的led静态显示试验-Max7219 done with single-chip microcomputer to control the led display static test

您上载的源码为何会被站长不采用或帐号被删除？请认真阅读您的文件包然后写出其具体功能 -You upload the source code for that station will be used or not account is deleted? Please carefully read the package to your specific function and then write