在IAR环境下LPC2368，sd卡的读写程序

ARM 4510b bootloader

dsp2812中关于can总线的例程，此程序用于can总线的运行-dsp2812 on the can bus routines, this program for the bus can run

本示例描述如何校准 RTC / * 在此示例中： * 假设 RTC 需要定期调整后每隔 5 秒. * 和时间计数器需要通过增加计数器，而不是 1 2 * 我们将通过串行显示校准后观察定时计数器 */

This a simple bootloader for AT91SAM7{S,X}{64,128,256} processors. It permits you to download new code to the device over USB. This bootrom is installed at address 0x00000000 in the ARM, which means that it is the first piece of code to execute after reset. At startup, it waits for a few seconds to see if the downloader is trying to connect. If not, then the bootloader gives up control and jumps to your program. If the downloader is trying to connect, then the bootloader receives the new program over USB and writes it into flash.

IAR MSP430F149 12位AD程序-IAR MSP430F149 12 AD procedures

单片无限收发芯片的一些资料，包括电路图，印版图，程序-chip transceiver chip unlimited some of the information, including schematics, printed map, procedures

Atmel Uart C51程序（从方式）-Uart (from the way)

lcd 1602使用程序 调试过 可放心使用-lcd 1602 over the use of program debugging can be assured the use of

arm开发软件：ADS中文教程-software development arm : ADS Chinese Guide

armlinux入门笔记，很好，很强大，还要20字-armlinux entry notes, very good, very strong