SONIX SCM's original code! Is to use A/D MCU I do one of the procedures char...

2410上的ad转换实验，从学校实验室下的-2410 on the ad conversion experiments, from the school laboratory under

Cortex ARM-M4 STM32F4XX使用的硬件模块CRC.计算CRC32带poly 0x04C11DB7（以太网）任意长度缓冲区。Keil 4的项目。

4510b的启动源码-4510b start FOSS

针对VRTX详细介绍了嵌入式实时操作系统的原理和应用，特别是第一部分关于嵌入式实时系统基础的介绍非常适合初学者全面地了解嵌入式实时系统，同时也对需要了解嵌入式系统开发的朋友有所帮助，是一部很好的教材。 -against VRTX details of the embedded real-time operating system and application principles, especially the first part of the embedded real-time systems based on very suitable for beginners to understand fully embedded real-time systems, but also requires an understanding of embedded systems development help friends, is a very good materials.

这是运行在S3C2440+linxu上的SPI控制器驱动程序，里面包含Makefile-This is running on S3C2440+ Linxu the SPI controller driver, which contains Makefile

MIPS Assembly Code - Hello World example-MIPS Assembly Code- Hello World example

用LPC213X系列的PWM来产生语音。语音数据来源于PC机转换后得到的。最大可以是16位的。 由于是PWM所以输出端口需要低通滤波才能够得到比较干净的声音。 可以经过修改使用LPC2132以上的ARM的D/A来产生。 This project outputs audio on PWM0 using wave samples that are stored in the on-chip Flash ROM. -LPC213X series used to generate the PWM voice. Voice data from the PC after the conversion. It is the largest of 16. Because there is PWM output ports need low-pass filter can be relatively clean voice. It has been modified over the use LPC2132 ARM D/A to produce. This project outputs audio on PWM0 using wave samples that are stored in the on-chip Flash ROM.

lcd 1602使用程序 调试过 可放心使用-lcd 1602 over the use of program debugging can be assured the use of

mc9s12XDP512单片机 AD0程序-mc9s12XDP512 MCU AD0 program

s3c44b0,开发板上测试usb的host/device的源程序，ads调试通过-s3c44b0, development board test usb the host/device source, Debugging through ads