SmartGen generated with a size of 256* 8 Synchronous FIFO, and sending data thro...

use lpc2148 develop usb mem

AT45D041大容量IC卡 读写程序,不知现在还有没人用，以前我用过的一颗芯片。-AT45D041 large-capacity IC card reading and writing process, I wonder if there is no one now, and I used a single chip.

利用单片机做的编码器输出值LED显示程序，用MAX7219驱动七段数码管，完成二‘十’十六进制的切换显示。-Does the use of single-chip encoder output LED display program with Seven-Segment LED Driver MAX7219, completion of the second

一些实用的51单片机接口源程序，里面附有文档说明，很好的开发参考资料-51 microcontroller interface source inside with documents show that the development of good reference

宏晶公司单片机的下载程序，支持ISP下载，支持自定义ISP，那包含串口调试软件-Acer crystal company SCM download and support ISP download, support custom ISP, it contains the serial debugging software

伟福 Lab2000P单片机仿真实验系统-Wei Fu Lab2000P single-chip simulation system

ad转换，8路温度自动测量，可以设置温度上下限，并能实现控制-ad conversion, 8-way automatic temperature measurement, you can set the temperature of upper and lower limits, and to achieve control of

用basic编写的t6963c控制器的液晶驱动程序。-t6963c display driver in basic.

这是用iar环境编译的程序， 主要适用于msp430f149单片机 程序的内容是模拟比较器。-This is used to compile the procedure iar environment, mainly applicable to MSP430F149 single-chip process is the analog comparator.

1.将P1.0～P1.3接开关，将P1.4～P1.7接发光二极管。依据P1.0～P1.3开关状态控制P1.4~P1.7发光二极管点亮。 2.将P1.0～P1.7全部接发光二极管，开始P1.0、P1.5点亮，左循环50次后P1.1、P1.4点亮；右循环30次，循环往复。-1. P1.0- P1.3 will then switch to P1.4- P1.7 access LEDs. P1.0- P1.3 based on state control switch P1.4- P1.7 LED lights. 2. P1.0- P1.7 will take all LEDs started Schematic, P1.5 lit, the left circle after 50 P1.1 and P1.4 lit; Turn right circle 30 times repeated.