16C84 use routines include : 16C84 RB I interrupt procedures and 16C84 do smart...

AVR单片机入门及C语言高效设计实践(13)源程序码-AVR单片机入门及C语言高效设计实践13)源程序码

STC12C5410AD温湿度采集并将模拟量通过对半查找法查表转换-STC12C5410AD simulation of temperature and humidity and the amount collected through semi-look-up table to find the conversion law

msp430 AD DEMO程序! 不错的,适合于刚学430的朋友!-Controller AD DEMO procedures! Yes, just learning to fit in the 430 friends!

用于智能公交设备的WW-989，用STC89C2051控制串口芯片与4094的源程序，非常好用哦-For intelligent transportation equipment, WW-989, with serial STC89C2051 control chip and the source 4094 is very easy to use, oh

单片机AT90S系列 制作简易USB接口（软件模拟,无usb硬件）。doc- Monolithic integrated circuit AT90S series manufacture simple USB connection (software simulation, non- usb hardware). Doc

该程序为t6963控制器的c语言驱动程序，内有proteus的模拟仿真图形，是单片机学习的好例程！-procedures for the t6963 Controller c language driver, proteus within the simulation, graphics, SCM is a good learning routines!

sed1520的122*32点阵液晶驱动的单片机程序-sed1520 122* 32 dot-matrix LCD driver of SCM procedures

普通IO口模拟RS232串口 占用定时器0中断 在TH0,TL0中设置波特率的大小 注意不要开定时器0的中断，这里用的是查询方式-ordinary RS232 serial I simulated occupancy Timer 0 interrupt the switching, TL0 set baud rate to the size not to open the Timer 0 interrupt here with the inquiry

upsd3200_adc.c upsd3200_lcd.c upsd3200_pwm.c upsd3200_timer.c uPSD的实用程序-upsd3200_adc.c upsd3200_lcd.c upsd3200 _pwm.c upsd3200_timer.c uPSD practical procedures!

环境测量系统毕业设计大礼包 // 系统一直监测环境光线状况,如果光线太强或者太弱,系统会自动提示 利用61板的KEY3键控制温度测量及语音播报,每按一次KEY3键,61板播放一次温度值及温馨提示,如果光线柔和,同样会播放"光线柔和"-Environmental measurement system design big graduation gift// system has been monitoring ambient light conditions, if the light is too strong or too weak, the system will automatically prompt the use of 61 key control panel KEY3 temperature measurement and voice broadcast, every time KEY3 key board player 61 a temperature value and the gentle suggestion that if the soft light, soft light will also play