ARM LPC21XX proteus测试,测试已经完好,可以直接使用.谢谢!

飞思卡尔单片机的EEPROM 的PE编程，许多初学者都不能很快进行EEPROM编程，而使用PE却可以使编程简化。-Freescale MCU EEPROM of the PE program, and many beginners can not be very soon EEPROM programming, the use of PE is able to make to simplify programming.

C51写的Zi2020 FM发射模块控制代码！-C51 wrote Zi2020 FM transmitter module control code!

步进电机步距角细分的单片机控制系统设计和研究,主要是设计方案-stepper motor step angle breakdown of the single-chip microcomputer control system design and research, the program is designed

pic单片机与PC机的485通信程序，实现了232转485的功能-pic Microcontroller and PC-485 communication procedures, to achieve a 232 to 485 function

这是参加电子设计大赛时的作品：红外遥控小车：用红外线通过一块AT89S52单片机发射信号即编码，并用红外接收头接收信号；接着再用另一块AT89S52单片机对红外发射出的信号编码进行解码，最后再用一块AT89S52单片机用解码所得码值编写程序后驱动步进电机。步进机功能启动后不仅能使受控小车向前后左右四个方向前进和转弯，而且还能控制小车再地上转动并留下方形或圆形等形状。-This is the time to participate in Electronic Design Contest works: infrared remote control car: Using infrared transmission signal through an AT89S52 microcontroller that is encoded and used infrared receiver to receive the first signal and then using the other an infrared emitting MCU AT89S52 code and decode the signal and finally an AT89S52 microcontroller then proceeds with the decoding key value of the preparation of procedures to drive a stepper motor. Stepper machine function activated not only make the car forward in a controlled direction and after about four turns, but also to control the car and then turned and left the ground such as square or round shapes.

DS18B20的驱动程序。通过KEIL C编译，在AT89S51上运行正常。-DS18B20 drivers. Through the KEIL C compiler, in the normal run AT89S51.

51单片机收发短信的程序，W77e58单片机外括16kram就行-51 SCM SMS procedures, including W77e58 SCM 16kram on foreign firms

凌阳单片机的串口通信程序，在SPCE061A芯片上调试通过-Sunplus Single-chip serial communication procedures, in SPCE061A chip debugging through

基于ARM7的GPRS实验代码(LCD320,键盘,I2C总线)-ARM7-based GPRS experimental code (LCD320, keyboard, I2C Bus)

C51实现的FAT32文件系统-C51 of the FAT32 file system