实现了对红外遥控器的解码及响应，并能进行LCD显示。

液晶显示程序，初始化、命令字的控制，完整版-LCD procedures, initialization, command control characters, the full version

51 红外实验-51 Infrared Experiment

DS18b20温度计,可以检测温度的变化，精度高-ds18b20

keil c51 小模式下uc/os应用，版本keil uv2 6.12，很好用-decoder mode uc/os application, version 6.12 Keil uv2 good use

51红外线解码9102的程序，高效简单抗干，改一下可用于6122。-51 IR 9102 decode the procedure simple and efficient anti-stem, to what can be used for 6122.

本文档格式为PDF文件,讲述ADUC841单片机的资料,这是一款性能和速度都很好的单片机,速度快,内部资源丰富.-This document format PDF documents, information on the ADuC841 MCU, which is a very good performance and speed of single-chip, high speed, the internal resource-rich.

Atmel Uart C51程序（timer2方式）-Uart (timer2 way)

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

凌阳16位机 SPL501驱动程序－显示字符-Sunplus 16-bit machine SPL501 driver- display characters

在单片机上实现对工业现场的多模态PID控制源代码,方面大家参考-In SCM to achieve the industrial scene, multi-mode PID control of source code, refer to aspects of U.S.