LCD12232显示实验源代码，适合51,AVR,ARM单片机使用。

通过测试已经可以应用 本程序的应用于C8051F020的I2C接口-Has passed the test can be applied to this procedure applies to the I2C interface C8051F020

C8051F120 UART 完整程序 ，自己编的， 测试通过-C8051F120 UART complete program, its compilation, and test

1602 4线驱动 亲自测试可用 内附 Preteus原理图-16024-line-driven test is available

用proteus进行的开发，和刚上传的c文件一起用-Proteus carried out with development, and the newly uploaded file with c

此程序为自行车计附带产品．可以计里程，计速度．清零等功能．采用霍尔传感器传输信号，单片机采用中断扫描．然后用数组的形式在LED上显示．-procedure for bicycles or spin-off products. Total mileage can be up speed. Reset function. Hall sensor used for signal transmission interrupt SCM scan. Then in the form of an array of LED show.

AVR单片机MEGA8写CC1000的C代码，是十分有用的资料-AVR MEGA8 CC1000 write C code is very useful information

该算法为带低通滤波的PID控制仿真源代码 用MATlab开发，能够管直接运行-The algorithm for the low-pass filtering with the PID control simulation using Matlab source code development, to pipe directly to run

将单片机的IOA0~IOA7分别接按键S1~S8连接到高电平上。此时，如果某个按键被按下，对应的I/O端口就会输入高电平进单片机，即按键S3按下，IOA2会输入高电平进单片机-Will Singlechip IOA0 ~ IOA7 access keys, respectively, S1 ~ S8 is connected to high on. At this point, if a button is pressed, the corresponding I/O port will enter into the high single-chip, that is, S3 button press, IOA2 will enter into single-chip high

keilc51 startup代码解释 -keil c51 startup source code explain

用51单片机控制硬盘读写，并用通过液晶界面显示。-SCM control with 51 hard drives to read and write, and use the LCD interface display.