简单的程序，硬件调试，并通过自己的网页自己画..

定时记数模块！对44B0的3号定时器编程。-regularly credited several modules! Right 44B0 of the 3rd timer programming.

一个测试你网卡dm9000好坏的测试程序 很好用 已经通过本人调试-A test of your network adapter dm9000 mixed well with the test procedure has been adopted my debugging

ARM启动的一篇文章-ARM started an article

描述了如何配置stm32f10x的ADC控制寄存器，ADC1被配置为有顺序地转换第14与17通道的模拟输入量，ADC2被配置为有顺序地转换第10与11通道的模拟输入量。-This example describes how to use ADC1 and ADC2 in regular simultaneous dual mode. ADC1 is configured to convert channel14 and channel17 regular channel continuously. ADC2 is configured to convert channel10 and channel11 regular channel continuously.

at91rm9200硬盘的接口代码，并带有ucfs的实现-AT91RM9200 hard disk interface code, and with the realization of ucfs

基于s3c2410嵌入式GPS开发模块的源代码-GPS Embedded Development Module source code

这是关于NEC公司产的SH2系列芯片的几个例子程序,对这几个熟了,就很有利于基于其上的开发的展开-This is on the NEC Corporation of the SH2 family of chip production a few examples of procedures, a few cooked this, it is very conducive to the development on the basis of their unfolding

STM32非固件库程序，实现功能：ADC3-Non-STM32 firmware library program, to achieve functional: ADC3

静态显示8051程序， 将预置在显示缓冲区中的6个数置换成相应的显示字形，然后输出到显示器中显示。运行以上程序，数码管将显示543210。-static display 8,051 procedure will be preset in the display buffer of 6% corresponding number of replacement shows font, then the output to a monitor display. Run the above procedures, digital pipe to show 543,210.

基于AMD X86构架的嵌入式处理器SC520的4串口驱动程序(带缓冲)-AMD X86-based embedded processor architecture of the four SC520 Serial Driver (buffer zone)