arm软件调试程序，可以代替jtag方针器对arm进行软调试，也可嵌到开发软件中。...

MAX038 的中文资料及说明-Chinese MAX038 information and explanations

This example program shows how to configure and use the A/D Converter of the following microcontrollers: * Philips LPC 2114/2119/2124/2129/2131/2132/2138/2194 After configuring the A/D Converter, the program reads A/D channel 0 and outputs the converted value using the serial port. To run this program... 1. Select the Device (Project - Options for Target - Device) 2. Build the project (Project - Build Target) 3. Start the uVision Debugger 4. Open the Serial Window (View - Serial Window 1) 5. Click Run (F5) 6. Click on the Toolbox buttons to change input voltages A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change. Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µ Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals grap

这是程序配置液晶显示器在STM32。  该计划是写在KEIL

键盘应用程序，对于粗学很有用途，望大家努力学习啊-Keyboard applications, for the very purpose of rough places, hope you study hard ah

通过四个红外扫描对小车进行运动轨迹控制，采用STC89C52，控制两个直流电机

CAN implementation on ARM7TDMI microprocessor

此示例是为 LPC1788 AT24C02 本示例描述如何使用软件 I2C 驱动与 AT24C02

本软件实现了FLASH底层驱动包括NOR FLASH与NAND FLASH-The software achieved a FLASH drive, including the bottom NOR FLASH and NAND FLASH

LPC2210串口测试程序-Serial Port Testing Program of LPC2210

pl2200 zfc 开发全部文档,源码,-pl2200 zfc development of all documentation, source code,