H4100 RF card driver, the application of tried and tested procedures

UCOS――FOR――UNSP2，ucos在凌阳单片机上的移植。-UCOS-- FOR-- UNSP2, Sunplus CENTER SCM in the transplant.

c语言编程的8位密码锁，用Protues进行仿真，效果不错-c language programming of eight locks with Protues simulation, good results

利用51单片机控制红外遥控的发射部分的程序，该程序在51单片机的基础上，采用一定的协议，进行编码、调制和发送等，具有很实用的价值。-51 SCM control the use of infrared remote control transmitter of the program, the program in MCS-51, based on the use of certain agreements, coding, modulation and delivery and so on, have a very practical value.

采用tenx TMU3110开发的一个HID的示例程式 包括单片机程式 ,PC端USb接收程式-used tenx TMU3110 development of a program HID examples include SCM programs, PC program receiving end USb

设计分为5 个模块：前轮PWM 驱动电路、后轮PWM 驱动电路、轨迹探测 模块、障碍物探测模块、光源探测模块。前轮PWM 驱动电路用于转向控制；后 轮PWM 驱动电路用于方向和速度控制；-Design is divided into five modules: front-wheel drive PWM circuit, rear-wheel drive PWM circuit, the track detection module, obstacle detection module, detecting the light source module. PWM drive circuit for front-wheel steering control rear-wheel drive circuit for PWM direction and speed control

51单片机驱动320*234彩显的源代码-51 Microprocessor 320* 234 Color source code

8051模拟板买不起的朋友可以和他们一起买

使用微芯公司的PIC8F458单片机，用C语言实现B口电平变化中断程序，并且在中断中用C实现步进电机的驱动程序。-The use of Microchip

压缩文件包括电磁炉的控制程序和其原理电路图！方便大家阅读程序，配合原理图阅读！-compressed files including Induction Cooker control procedures and its tenets circuit! To facilitate reading the procedure to incorporate the diagram read!

ARM7的一些程序代码,有点帮助,可以下来-ARM7 some code, a little help can be down Rare