串口转发IIC程序，用MEGA16实现，调试IIC接口时非常有用。

LPC2103的第二个实验：流水灯+按键，用proteus7仿真，C语言代码，在Keil3中编译，文件内已有完整的工程和仿真图了。-The second experiment LPC2103: water lamp+ button, and proteus7 simulation, C language code, compiled at Keil3 in the paper that has a complete map of the engineering and simulation.

这是个火车传感器的小程序，在某车厢里存放N个传感器，当某个传感器温度超过或者低于某个指定范围，系统发出警告。-This is a small sensor train procedures, in a vehicle storage N sensors, When a sensor temperature is over or below a certain designated areas, the system issued a warning.

can总线应用

悠景2.7寸OLED演示代码，可以在DEMO板上测试-Univision 2.7-inch OLED demo code, you can test at the DEMO board

使用PROTEUS仿真的RS232串行通信口,可在串口助手输入,激活7段数码管显示相应的数字-PROTEUS simulation using RS232 serial communication port, serial port assistant in the input, activation of 7 digital tube display the corresponding figure

利用51单片机控制ISD2560语音芯片实现语音的录放和存储，可自动调用，很实用的程序，绝对原创！-51 SCM control the use of voice chip ISD2560 voice playback and storage, can automatically call a very useful procedure, an absolute original!

无线芯片CC1110和CC2510的应用电路图，有较强的参考价值。绝对没问题。-CC1110 and CC2510 radio chip circuit applications, there is a strong reference value. Absolutely no problem.

AVR309-USB 到 UART 协议转换程序。-AVR309-USB to UART protocol conversion process

Atmel atmega16 with t6963 (avrstudio)

一个用keil 51c实现的单片机系统程序，实现led显示和其他一些模块的控制-Using keil 51c realize a single-chip microcomputer system of procedures, led display and realize a number of other control modules